Z-Wave ZRC-100 Spécifications télécharger pdf (Page 49)

⇓

Select “Create a Sec.”

then press

key.

Please make sure the

target secondary

controller is setup to

receive information

mode.

(e.g. target secondary

controller should entry

the “Learning mode＂

if this is a another ZRC-

100. Please refer to the

target controller user

manual for more

information)

=> Target secondary

controller will act as a

secondary

controller

after this action.

=> Original ZRC-100

primary controller will

still keep in a primary

controller after this

action.

⇓

Create a Primary Controller

(Transferring Only Network Information to a New Primary Controller)

You can just transfer network information to another remote so that it

will act as a new primary remote. This primary shift

is done by

following the steps below.

Create a Sec.

Copying…

>>>>

Create a Sec.

Copying…

>>>>

Network Setup

Rediscover N.W. >

Delete Dead Node >

OK to Enter

Re-scan Devices >

Network Setup

Listenin

Mode >

OK to Enter

Create a Sec. >

Create a Pri >

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

Z-Wave ZRC-100 Spécifications Page 49

Commentaires sur ces manuels

Produits connexes et manuels pour Télécommandes Z-Wave ZRC-100